NOTE: If you’re using 16″ x 12″ on your table saw, remember to make sure it will fit the cross section without significant extra room. hollyhollyswanson.com

7. Move the tool strip from the side brace to the left. hollyhollyswanson.com

6. Use 1/8-in. threaded rod to screw the panel to the cross section hollyhollyswanson.com

This 8-way bootmaker only requires 2 power tools to build. All the tools used in my builds, are provided by Homeboy. The overall cost of this build was $100.00 with my rebate on…

10. Get your screws/washers ready hollyhollyswanson.com

See all 8 Ways to Build a Bootmaker Workbook entries! hollyhollyswanson.com

8. Stop the panel on the second cross section and drill with a 3/8-in. drill bit through the panel hollyhollyswanson.com

9. Finish the plywood panel hollyhollyswanson.com